Advertisement
Technical Bulletin
If you are experiencing a gap between frames, try the following to solve:
1.
Level and align the plotter (See chapter 8 of your Guide to Operations "Aligning
the Plotter").
2.
Review paper loading. Ensure paper is taught when attached to the take-up
shaft.
3.
Remove any paper build up on the grit shaft with a stiff bristled nylon brush.
Paper build up will cause the paper to slip under the chart wheels.
4.
Chart wheel placement is crucial. Position each chart wheel pair in 2' from the
edge of the paper.
5.
Remove any foreign matter from the chart wheels that may hinder them from
rotating freely.
6.
Reposition the chart wheels over an area of the grit shaft that's had minimal use
in order to grip the paper better.
7.
Ensure the dancer bars are not sticking at the top of the guide, which could
cause the paper to become unbalanced.
8.
Paper Quality.
performance.
9.
Clean the sensor lens using a cotton swab and isopropyl alcohol.
10.
Adjust the focal point of the sensor.
11.
Use only black ink pens to allow the sensor to pick up the frame mark more
consistently.
Ioline recommends using 35 lb. Bond paper for optimal
Frame Gap/
Stylist 2000 & LP 7200
Advertisement
