Related Manuals for Ioline Stylist 2000
Summary of Contents for Ioline Stylist 2000
- Page 1 Technical Bulletins Stylist 2000 & LP 7200 TABLE OF CONTENTS Dimensional Calibration Frame Gap Frame Sensor Adjustment Rollfeed Parameters Y-Axis Registration...
- Page 2 0.05%. The microcalibration should be performed each time you use a different type of paper. To calibrate your Stylist 2000 or LP 7200: Load paper. From the keypad set the lower left and size, then press (F3) “Action” (F2) “Tests”...
- Page 3 If the value you have entered is correct, press the “Enter” key to set the x measurement. Press “Enter” to <Power Up Default>. Follow steps 7 & 8 to set the y coordinate. Calibration is complete.
- Page 4 Ensure the dancer bars are not sticking at the top of the guide, which could cause the paper to become unbalanced. Paper Quality. Ioline recommends using 35 lb. Bond paper for optimal performance. Clean the sensor lens using a cotton swab and isopropyl alcohol.
- Page 6 Technical Bulletin Frame Sensor Adjustment/ Stylist 2000 & LP 7200 Turn the sensors vertical height adjustment screw clockwise; lowering it to within 1/8 inch (1/4 cm) of the paper. Select the media size (see page 6 - 3 of your Guide to Operations).
- Page 7 Technical Bulletin Rollfeed Parameters/ Stylist 2000 & LP 7200 Rollspd When this option is selected, the user is prompted to enter a new Slow Speed and a new High Speed. These values are the low and high power settings applied to the rollfeed motor during frame advances and loop feeds.
- Page 8 start to move the gritshaft and increasing the Rollspd slow speed causes excessive snapping of the paper. AloneX Spd: Default = 20 Range = 1 to 40 (power setting)
- Page 9 Technical Bulletin Y-axis Registration/ Stylist 2000 & LP 7200 If you are experiencing y-axis registration problems, check the following: 1. Worn or loose y-axes drive belt. You can measure the y belt tension by moving the carriage all the way to the right end plate. The y belt should be firm and taut, but not stretched.