Rear Panel
MKS-R3210/R1620/R1630
b LAN1 port
c LAN2 port
a U (ground) terminal
For signal grounding.
b LAN1 (PoE) port
Connect to the network with system controller connected
(network 1). This port accepts power using PoE.
CAUTION for LAN port
The LAN port of this unit is to be connected only to the
devices whose power feeding meets the requirements for
SELV (Safety Extra Low Voltage) and complies with Limited
Power Source according to IEC 60950-1.
CAUTION
When you connect the LAN cable of the unit to peripheral
device, a shielded-type cable is strongly recommended to
prevent malfunction due to radiation noise and electrostatic
noise.
c LAN2 port
Connect to the network with system controller connected
(network 2).
CAUTION for LAN port
For safety, do not connect the connector for peripheral device
wiring that might have excessive voltage to the following port:
• LAN2 port
Notes
• When you connect the LAN cable of the unit to peripheral
device, a shielded-type cable is strongly recommended to
prevent malfunction due to radiation noise and electrostatic
noise.
• If a redundancy configuration is not used on the network,
use the LAN1 port.
d DC IN connector
Connect to the supplied AC adapter.
a U (ground) terminal
7
d DC IN connector