Alias Name Lists Page; Default Controls Page; Operation Settings Page - Sony MKS-R3210 Operating Instructions Manual

(Destination)
When a destination outside the range limit is selected,
sources 1 to 9999 are available for selection. In this example,
sources 0001 to 9999 are available for selection for
destination 3001.
The sources in the range containing the selected destination
are all enabled. In this example, sources 0001 to 3000 and
5001 to 8000 are available for selection for destination 0001.
Adding a range
1
Click the [+] button.
2
Enter a source range and destination range in the
dialog.
3
Click the [Apply] button.
The specified settings are displayed in the list.
Selecting a row in the list displays a blue rectangle
covering the range available for selection.

Alias Name Lists Page

Displays alias names sent from the system controller.
Select [Source] or [Destination] to display the list of alias
names for sources or destinations, respectively.

Default Controls Page

Use to set the operation levels and default destination of the
unit.
Default Page
Startup Page
(Not available on the MKS-R3210)
Set the page to display after power is turned on.
(Source)
Configured area
Unconfigured area
28
Note
Set the pages to include in the page group to use on the
"Page Group Settings Page" (page 31).
Destination Settings
Control Destination
Set the destination that is selected when power is turned on.
Enable set control destination by page
(Not available on the MKS-R3210)
If you configure a destination for each page and then switch
pages, this enables the function to change the control
destination to the configured destination for that page.
Level Settings
Level Mode
(Not available on the MKS-R3210)
Select level selection mode.
Single: Only one level can be selected. When a selection
button is pressed, only that level is enabled, and other
selected levels are de-selected.
Multi: Multiple levels can be selected. The levels for a pressed
selection button are all selected. When a selected button
is pressed, the levels of that button are de-selected.
Use Level Type
Select the levels to use in the unit.
System: Use the levels specified by the system controller.
Local: Place a check mark in levels to set the levels used by
[Control Level].

Operation Settings Page

Use to configure settings relating to the operation of the
remote control panel.
Mode Settings
Protect Mode
Set the operation mode when protection is applied. The
PROT lamp action is the same when either mode is selected.
Protect: Crosspoint switching is disabled when protection is
applied.
Occupy: Crosspoint switching of protected remote control
panels only is enabled when protection is applied.
Salvo Protect
This selects the process if salvo switching is executed while
destinations are protected.
Partial Protect: Switch only unprotected destinations.
Full Protect: Do not perform salvo switching if any one of the
destinations is protected. Select this mode if a problem
would occur if any one location does not switch.
Button Link: Do not perform salvo switching if the PROT lamp
on the panel is lit.
Note
When [Protect Mode] is set to [Occupy] in the web menu to
enable local protection, salvo switching is not restricted by the
[Salvo Protect] setting.
BPS/MD Take Mode
(Not available on the MKS-R3210)