Table of Contents
Advertisement
11 TUNING THE CHASSIS
11.16
54
Adjusting the handlebar position
Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged or bent.
F02950-10
–
1
Remove screws
. Take off the handlebar clamps. Take off
the handlebar and lay it to one side.
Info
Cover the components to protect them against dam-
age.
Do not bend the cables and lines.
–
2
Remove screws
. Take off the handlebar supports.
–
Place the handlebar supports in the required position. Mount
2
and tighten screws
.
Guideline
Screw, handle-
M10
bar holder
Info
Position the left and right handlebar holders evenly.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor-
rectly.
–
Position the handlebar clamps. Mount and tighten screws
evenly.
Guideline
Screw, handlebar
clamp
Info
Make sure the gap width is even.
40 Nm (29.5 lbf ft)
Loctite
M8
20 Nm (14.8 lbf ft)
®
243™
1
Advertisement
Table of Contents
