Initial Network Configuration - Meinberg IMS-LANTIME M500 Manual

6.3 Initial Network Configuration
After the system has been connected to the power supply and to the receiver antenna, the initial start-up can
be started. The device starts immediately after connection to the power supply.
An IMS LANTIME system is shipped with DHCP service enabled on the LAN 0 interface. This means that you
have to establish a manual network connection if no DHCP service is installed in your network environment in
order to perform system settings via the web interface.
Initial network configuration via the LC display.
Except for models with S-chassis, all LANTIME IMS systems have a display with control keypad. The following
figure shows the individual steps you have to perform to read out an IP via the display or to set the IP manually.
MRS: Sync to GPS
NTP: Offs.+1us
Tue, 13.04.2021
UTC 10:25:51
Use Up and Down
to select Port:
lan0:0 #1of1 i
>172.28.12.1
Set LAN Address <-
IPv4 lan0:0 :
-> DHCP: enabled<-
172.28.12.1
For manual configuration, you have to disable the DHCP service. After that the IP can be configured using the
" " buttons. Always confirm your entry with the OK button to save the changes.
IMS - LANTIME M500
Ref. Time
Time Service
-> Network <-
System
> IPv4 Parameter <
IPv6 Parameter
OK
Link Mode
Set LAN Address
OK
IPv4 lan0:0 :
DHCP: disabled
Date: 28th May 2021
6 System Installation
-> Interfaces <-
Global Cfg.
OK
Services
Add Interf.
> LAN Address <
LAN Netmask
OK
Gateway
OK
Set LAN Address
IPv4 lan0:0 :
*72.028.000.012
OK
OK
OK
43