Safety: If Your Device Gets Wet; Safety: If You Drop Or Damage Your Printer - Dell 5330dn Product Information Manual

If your equipment uses a replacable battery:
WARNING:
Replace the battery only with the same or equivalent type recommended by the
manufacturer. Discard used batteries according to the manufacturer's instructions.

SAFETY: If Your Device Gets Wet

WARNING:
General Safety section of this document.
WARNING:
printer is connected to an electrical outlet, turn off the AC power at the circuit breaker, if
possible, before attempting to remove the power cables from the electrical outlet. Use the
utmost caution when removing wet cables from a live power source.
1
Disconnect the AC adapter from the electrical outlet, and then, if possible, disconnect the
AC adapter from the device.
2
Turn off any attached external devices, then disconnect them from their power sources, and
then from the device.
3
Contact Dell support (see your User's Guide or Owner's Manual for the appropriate contact
information).

SAFETY: If You Drop or Damage Your Printer

WARNING:
General Safety and Power Safety sections of this document.
WARNING:
or unusual odors are detected, disconnect the device from the electrical outlet and contact
Dell support. See your User's Guide or Owner's Manual for the appropriate contact.
1
Save and close any open files, exit any open programs, and shut down the computer.
2
Turn off the printer and disconnect from the power source, and then disconnect from the
computer.
3
Turn off any attached external devices, and disconnect them from their power sources and
then from the computer.
4
Connect the printer to the power source and turn on the printer.
If the device does not start, or if and smoke or unusual odors are detected, or you cannot identify
the damaged components, contact Dell (see your User's Guide or Owner's Manual for the
appropriate contact information).
There is a danger of a new battery exploding if it is incorrectly installed.
Before you begin any of the procedures in this section, see the SAFETY:
Perform this procedure only after you are certain that it is safe to do so. If the
Before you begin any of the procedures in this section, see the SAFETY:
If any internal components can be seen through damaged portions, or if smoke
Product Information Guide
11