Approved Multiengines - Stihl FC-MM Instruction Manual

Edging
90°
Secure the handlebar in the normal
N
operating position.
Start the engine.
N
Start the cut at no less than half
N
throttle and continue cutting at full
throttle.
Hold and guide your edger so that
N
the blade is vertical.
Cut steadily so that the engine is not
N
lugged down – do not apply force.
Cut at no more than a normal
N
walking pace.
Do not push the blade into the
N
ground.
Always walk forwards when cutting,
N
do not pull the unit towards you.
Edge at a steady pace to avoid
N
having to make several passes.
FC-MM
1
Use the gunning sight (1) to line up
N
the blade on the edge.
Cleaning the blade
Pieces of grass or roots may become
tightly wrapped around blade mounting
during operation. Clean the blade as
follows:
Shut off the engine.
–
Wear work gloves.
–
Pull the hitch pins out of the axle.
–
Pull the blade off the axle.
–
Remove pieces of roots, plants and
–
soil.
Refer to "Mounting the MultiTool" for
mounting instructions.

Approved MultiEngines

Only use MultiEngines supplied by
STIHL or expressly approved by STIHL
for use with the MultiTool.
This MultiTool may only be used in
combination with the STIHL MM 56
MultiEngine.
English
7