Frigidaire FFBD1821MW Installation Instructions Manual

Frigidaire FFBD1821MW Installation Instructions Manual

Built-in
Hide thumbs Also See for FFBD1821MW:

Advertisement

Quick Links

I n s t a l l a t i o n
I n s t r u c t i o n s
If you have questions, call 800-944-9400(US), 800-245-8352 (Canada) or visit our website at:
www.Frigidaire.com
BEFORE YOU BEGIN
Read these instructions completely and
carefully.
IMPORTANT
governing codes and ordinances.
• Note to Installer – Be sure to leave these
instructions for the consumer's and local
inspector's use.
• Note to Consumer – Keep these instructions
with your Owner's Manual for future reference.
• Skill Level – Installation of this dishwasher
requires basic mechanical and electrical skills.
Proper installation is the responsibility of the
installer. Product failure due to improper
installation is not covered under the
ELECTROLUX Appliance Warranty.
• Completion Time – 1 to 3 Hours. New
installations require more time than replacement
installations.
READ CAREFULLY.
KEEP THESE INSTRUCTIONS.
Observe all
B u i l t - I n
Dishwasher
IMPORTANT
MUST be installed to allow for future removal from
the enclosure if service is required.
If you received a damaged dishwasher, you
should immediately contact your dealer or builder.
Optional Accessories – See the Owner's Manual
for available custom panel kits.
FOR YOUR SAFETY
Read and observe all CAUTIONS and WARNINGS
shown throughout these instructions. While
performing installations described in this booklet,
gloves, safety glasses or goggles should be
worn.
WARNING
To reduce the risk of electrical shock, fire,
or injury to persons, the installer must
ensure that the dishwasher is completely
enclosed at the time of installation.
The dishwasher

Advertisement

Table of Contents
loading

Summary of Contents for Frigidaire FFBD1821MW

  • Page 1 B u i l t - I n Dishwasher I n s t r u c t i o n s If you have questions, call 800-944-9400(US), 800-245-8352 (Canada) or visit our website at: www.Frigidaire.com BEFORE YOU BEGIN IMPORTANT –...
  • Page 2: Parts Supplied

    Installation Preparation PARTS SUPPLIED: ¨ Two #8 Phillips flat head wood screws, 5/8” long to secure dishwasher to underside of countertop (in literature package). ¨ Two Phillips head, color matched toekick screws (in 2 Wood Screws Screw Type 2 Color Matched literature package).
  • Page 3: Prepare Dishwasher Enclosure

    Installation Preparation • The dishwasher must be installed so that drain hose is PREPARE DISHWASHER ENCLOSURE no more than 10 feet in length for proper drainage. • The dishwasher must be fully enclosed on the top, sides and back, and must not support any part of the enclosure.
  • Page 4 Installation Preparation PREPARE ELECTRICAL WIRING WARNING FOR PERSONAL SAFETY: Remove house fuse or open circuit breaker before beginning installation. Do not 1-1/2" Dia. use an extension cord or adapter plug Hole (Max.) with this appliance. Electrical Requirements 3" • This appliance must be supplied with 120V, 60 Hz., from and connected to an individual properly grounded Cabinet...
  • Page 5: Prepare Hot Water Line

    Installation Instructions PREPARE HOT WATER LINE BEFORE YOU BEGIN • The line may enter from either side, rear or floor Locate and set aside the package containing within the shaded area shown in Figure F. 2 Phillips head countertop mounting screws •...
  • Page 6: Step 2 Adjust Leveling Legs

    Installation Instructions STEP 2 ADJUST LEVELING LEGS STEP 4 INSTALL 90° ELBOW • Move the dishwasher close to the installation location • Wrap 90° elbow with thread seal tape. and lay it on its back. • Install a 90° elbow onto the water valve. Fill Hose Adjust to...
  • Page 7: Step 5 Position Water Line And House Wiring

    Installation Instructions STEP 5 POSITION WATER LINE STEP 7 SLIDE DISHWASHER AND HOUSE WIRING PARTIALLY INTO CABINET DO NOT PUSH AGAINST FRONT PANEL • Position water supply line and house wiring on the WITH KNEES. DAMAGE WILL OCCUR. floor of the opening to avoid interference with base of dishwasher and components under dishwasher.
  • Page 8: Step 8 Position Dishwasher Under Countertop

    STEP 8 POSITION DISHWASHER UNDER COUNTERTOP Reposition Dishwasher • Check to be sure that wires are secure under the by Grasping Both dishwasher and not pinched or in contact with door Sides With Hands springs or other dishwasher components. TIP: Check tub insulation blanket, if equipped. It should be positioned so it is not bunched up or interfering with door springs.
  • Page 9: Step 10 Secure Dishwasher To Countertop Or Cabinet

    Installation Instructions STEP 10 SECURE DISHWASHER STEP 11 CONNECT WATER SUPPLY TO COUNTERTOP OR CABINET In this step you will need the 2 Phillips special head Connect water supply to 90° elbow. screws set aside prior to Step 1. The dishwasher must •...
  • Page 10: Step 12 Connect Drain Line

    Installation Instructions STEP 12 CONNECT DRAIN LINE DRAIN LINE INSTALLATION • Connect drain line to air gap, waste tee or disposer FOLLOW ALL LOCAL CODES AND ORDINANCES. using either previously determined method. The drain hose molded end will fit 5/8”, 3/4” or 1” Method 1 –...
  • Page 11: Step 13 Connect Power Supply

    Installation Instructions STEP 13 CONNECT POWER STEP 14 PRE-TEST CHECKLIST SUPPLY Review this list after installing your dishwasher to avoid charges for a service Skip this step if equipped with power cord. call that is not covered by your warranty. Verify that power is turned off at the source.
  • Page 12: Step 15 Dishwasher Wet Test

    Installation Instructions STEP 15 DISHWASHER WET TEST STEP 16 REPLACE TOEKICK ¨ Turn on power supply (or plug power cord into outlet, if equipped). ¨ Turn dial to Normal “Wash” position. ¨ Close door. ¨ Check to be sure that water enters the dishwasher. If water does not enter the dishwasher, check to be sure that water and power are turned on.

This manual is also suitable for:

Ffbd2406nb9bFfbd2406nwoaFfbd2411nb6b

Table of Contents