Updating The Boot Program - Sony HSCU300RF Service Manual

4. A message "UPDATE MAIN BLOCK ?" appears. Turn the CANCEL/ENTER lever to the ENTER side.
DISP/MENU lever
CANCEL/ENTER lever
Control knob
(Rotary encoder)
5. Check that "LOADER BLOCK COMPLETE!!" appears and then "MAIN BLOCK COMPLETE!!" appears.
6. Turn off the power and remove the Memory Stick.
7. When the unit is turned on, the main program is updated and runs.
8. Check that the main program has been updated with "ROM Version" of status display. (Refer to the Operation
Manual.)
1-4-2.

Updating the BOOT Program

Equipment Required
Memory Stick
Check
Check the current boot program version with Firmware Update of the MAINTENANCE menu. (Refer to
MAINTENANCE Menu")
Preparation
Copy the updating program to the Memory Stick in the following steps.
Note
To get the updating program (program files "HSCU300R.rom" and "HSCU300R_BOOT.rom"), contact your local Sony
Sales Office/Service Center.
1. Make the following directory on the Memory Stick.
\MSSONY\PRO\CAMERA\HSCU300R
2. Copy the program files "HSCU300R.rom" and "HSCU300R_BOOT.rom" to the directory made in step 1.
Procedure
1. Turn on the power.
2. Insert the Memory Stick that contains the updating program into the Memory Stick slot on the rear panel.
3. Select VERSION UP EXEC from BOOT on the M02: Firmware Update page of the MAINTENANCE menu.
4. A message "UPDATE BOOT BLOCK ?" appears. Turn the CANCEL/ENTER lever to the ENTER side.
5. Check that version update is performed and a message "BOOT BLOCK COMPLETE!!" appears.
6. Turn off the power and remove the Memory Stick.
7. When the unit is turned on, the boot program is updated and runs.
8. Check that the boot program has been updated with Firmware Update of the MAINTENANCE menu. (Refer to the
"3-3. MAINTENANCE
HSCU300RF/HSCU300R
Menu")
"3-3.
1-6