Table of Contents
Advertisement
TROUBLE SHOOTING
SANDER IS OVERHEATING
This indicates the machine is dirty. Clean the ventilation holes, and blow out
with compressed air or clean with a dry cloth.
Overloading the machine will also cause overheating. Do not apply excessive
pressure.
EXCESSIVE SPARKING OCCURS
This indicates worn brushes. This problem is quickly remedied but you should
consult your CLARKE dealer for parts and advice.
SANDER DOES NOT OPERATE WHEN SWITCHED ON
Check to ensure the fuse is sound and replace if necessary. If the fuse is sound
or blows repeatedly, consult your CLARKE dealer.
DUST IS NOT EXTRACTED
Dust bag is full and dust extractor flue is blocked. Remove and empty bag,
and clear any blockage.
ACCESSORIES
The following sanding belts are available from your Clarke dealer.
40 Grit, pack of 10
60 Grit pack of 10
80 Grit pack of 10
120 Grit pack of 10 Part No. 6468046
SPARE PARTS
BS101 Dust collector bag
BS102 Motor Brushes
ENVIRONMENTAL RECYCLING POLICY
By purchasing this product, the customer is taking on the obligation to deal
with its safe disposal in accordance with the Waste Electrical and Electronic
Equipment (WEEE).
This product must not be disposed of with general household waste but be
disposed of according to the laws governing Waste Electrical and Electronic
Equipment (WEEE) at a recognised disposal facility.
This product contains valuable raw materials. Metal products should be taken
to your local civic amenity site for recycling.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
Part No. 6468040
Part No. 6468042
Part No. 6468044
10
Advertisement
Table of Contents
