Table of Contents
Advertisement
LEOPARD OPERATING INSTRUCTIONS
software should be used to calculate optimum splay
angles for loudspeakers and to predict coverage
patterns for arrays.
Figure 18: LEOPARD Rear GuideALinks Label
NOTE:
For more information on GuideALink
configurations, refer to the MG-LEOPARD/900
Assembly Guide (PN 05.243.080.01) available at
meyersound.com/documents.
LEOPARD Splay Angles for Top Flown
Cabinets
When flying LEOPARDs below the 900-LFC, MG-
LEOPARD/900 grid, or MTF-LYON/LEOPARD transition
frame, splay angles of –4.5 to +10 degrees are possible for
28
the top cabinet with the GuideALink configurations listed in
Table 5.
Table 5: LEOPARD (Top Cabinet) GuideALink Configurations
Rear
Front
GuideALinks
GuideALinks
Set To
Set To
.5°
0°
1°
0°
2°
0°
3°
0°
4°
0°
5°
0°
6°
0°
7°
0°
8°
0°
9°
0°
10°
0°
6°
+5°
7°
+5°
8°
+5°
9°
+5°
10°
+5°
NOTE:
When flying LEOPARDs from the
MG-LEOPARD/900 grid, a splay angle of
0 degrees is recommended for the top cabinet (rear
GuideALinks set to 5, front GuideALinks set to 0) to
ensure that the cabinet aligns with any lasers or incli-
nometers mounted on the grid. To add tilt to the top
cabinet, the actual grid should instead be tilted with
motors attached to the front and rear of the grid. If
just one motor is available, you can attach it to one of
the 13 center pickup points offset from the center of
the grid to achieve the desired tilt.
Resulting Angle
of Attachment
–4.5°
–4°
–3°
–2°
–1°
0°
1°
2°
3°
4°
5°
6°
7°
8°
9°
10°
Advertisement
Table of Contents
