Advertisement
FWE TOP MOUNT MOBILE HEATED CABINETS
INSTALLATION AND CARE
SERIAL AND MODEL NUMBER
These numbers are found on the nameplate (serial tag) affixed to
the unit by the electrical cord. Please record them in this booklet,
in the space provided on page 9. When ordering parts and/or
service, you will need to provide this information. The voltage and
amperage of the unit are also stamped on the serial tag.
UNPACKING
After uncrating your cabinet, remove all tape and padding which
held all doors, shelves, racks, cord, etc., in place during shipment.
ELECTRICAL REQUIREMENTS AND GROUNDING
FWE standard models operate on 110/120 volt, 60 Hz, 1 ph, A.C.
(unless ordered otherwise), and are equipped with a three prong
grounding cord plug for your protection against possible shock
hazards. Be sure to plug only into a properly grounded three
prong wall receptacle. If you have any questions with regard
to adequate wiring or grounding in your building, a qualified
electrician should be contacted before using your cabinet.
The amperage of your cabinet is stamped on the name plate
attached to the unit.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE
THE GROUNDING PRONG FROM THE CORD PLUG.
WARNING: ONLY A QUALIFIED ELECTRICIAN SHOULD
ATTEMPT TO REPAIR OR REPLACE ELECTRICAL
COMPONENTS OR WIRING.
BE SURE THAT MODEL IS UNPLUGGED FROM ELECTRICAL
SOURCE BEFORE REMOVING CONTROL PANEL.
4
Advertisement
