Starter - Husqvarna 570 Workshop Manual

Starter

Dismantling
!
WARNING!
If the spring is tensioned on the starter
pulley it can fly up and cause personal
injury.
Wear protective glasses.
1. Remove the four bolts holding the starter to the
crankcase and remove the starter. See fig. 1.
2. Pull out the handle 20-30 cm and take out the cord
from the slot in the starter pulley. See fig. 2.
3. Rotate the starter pulley anticlockwise until the ten
sion on the pulley is released.
4. Remove the central bolt (C) and take out the washer
and starter pulley (D). See fig. 3.
5. If the starter cord is to be replaced, cut it off pull out
the ends from the handle and starter pulley with
pointed pliers.
!
WARNING!
If the spring is tensioned on the starter
pulley it can fly up and cause personal
injury.
Wear protective glasses.
6. If the spring is to be replaced, remove the screws (E)
and the spring cassette (F).
Cleaning and inspection
Clean all components and check the following:
1. Starter cord.
2. The dogs on the starter pulley.
3. That the pawls on the flywheel are intact, spring
back towards the centre and move freely.
18 – English
STARTER
Fig. 1
Fig. 2
Fig. 3
A
D
E
F
B
C