Husqvarna 570 Workshop Manual page 41

Cleaning and inspection
Clean all parts and check that the fuel pipe is intact.
Assembly
1. If the chainsaw is fitted with hand grip heating, fit the
heating element if it has been removed.
See page 22 and 24.
NOTE!
Take care not to damage the fuel pipe and
throttle cable.
2. If the throttle lock has been removed, it should be
refitted before the tank unit and engine unit are
assembled. See page 17.
3. Lift the engine unit over the tank unit and push the
fuel, tankvent pipe and throttle cable into their holes
in the bottom of the carburettor space.
4. Fit the bolts (E and H). See fig. 2. Tighten the bolts
to the torque in the service data, page
5. Fit front handle with the bolts (D, F and G). See
fig. 2. Tighten the bolts to the torque in the service
data, page 10 and 11.
6. Fit the fuel pipe (B) on the carburettor and tankvent
pipe (C). See fig. 1.
7. Insert the throttle cable casing in the attachment and
hook on the throttle cable (A) on the carburettor.
See fig. 1.
8. Fit the cylinder cover, guide chain and bar.
See the Operator's Manual.
TANK UNIT
10 and 11.
English – 41