Specifications - Toro MM E-S Series Operator's Manual

Motor Controls
The following motor controls are found on all models:
Figure 10
1. Thermal-overload
protector reset button
2. On/Off switch
Motor On/Off Switch
The On/Off switch (Figure 11) allows the operator of the
machine to start and stop the motor. This switch is located
on the front of the motor. It is marked (ON) and (OFF).

Specifications

Note: Specifications and design are subject to change without notice.
Machine Specifications
Model
Batch Capacity
Total Volume
Length
(without tow pole)
Width
Height
Weight
Axle
Motor
3. Power cord
68012C
0.17 cubic m (6.0 cubic ft)
0.20 cubic m (6.9 cubic ft)
163 cm (64 inches)
86 cm (34 inches)
137 cm (54 inches)
250 kg (550 lb)
86 to 117 cm (34 to 46 inches)
extendable
1.5 hp Baldor Electric
Rotate the On/Off switch to the On position to start and run
the motor. Rotate the On/Off switch to the Off position
to stop the motor.
1. Motor On/Off switch
68018C
0.23 cubic m (8.0 cubic ft)
0.25 cubic m (9.0 cubic ft)
193 cm (76 inches)
86 cm (34 inches)
137 cm (54 inches)
275 kg (605 lb)
86 to 117 cm (34 to 46 inches)
extendable
1.5 hp Baldor Electric
11
Figure 11
68019C
0.23 cubic m (8.0 cubic ft)
0.25 cubic m (9.0 cubic ft)
193 cm (76 inches)
86 cm (34 inches)
137 cm (54 inches)
275 kg (605 lb)
86 to 117 cm (34 to 46 inches)
extendable
2 hp Baldor Electric
1
g020669