Lincoln Electric Air Vantage 600X-I Operator's Manual page 18

AIR VANTAGE 600X-I
®
ACCESSORY CONNECTION DIAGRAMS
WARNING
Shut off welder before making or removing any electrical
connections.
When connecting an accessory to the Air Vantage
following steps should be taken:
• Shut off the welder.
• Connect your leads for the desired accessory. For electrode
positive, connect the electrode cable to the "+" terminal of
the welder and work cable to the "-" terminal of the welder.
42V / 120V Wire Feeder
Voltage Switch
Weld Mode
Selector
Switch
ACCESSORY
CrossLinc Feeder
CrossLinc Remote
Across The Arc Feeder
(Non CrossLinc)
42VAC Bench Feeder
w/Voltage Control
(Flex Feeds, LN-25 Dual)
42VAC Bench Feeder
w/o Voltage Control
(LF Feeders)
Submerged Arc Controllers
(NA-3, LT-7)
ArcLink Feeders
(Power Feed)
TIG Module
Spool Gun Module
600X-I, the
®
FIGURE A.5
Weld Terminals
Switch
TABLE A.4
WELD MODE WELD TERMINALS
SWITCH SWITCH
CV
Stick, Tig, Gouging
CV
CV REMOTE
CV REMOTE
CV/CC REMOTE
ArcLink
TIG REMOTE
CV
A-10
For electrode negative, connect the electrode cable "-"
terminal of the welder and work cable to the "+" terminal of
the welder. Installation diagrams for common setups are
included on the following pages.
• Set the WIRE FEEDER VOLTMETER switch to either "+" or "-"
as required by the electrode type (See Figure A.6).
• The switch positions on the Air Vantage
dependent on the type of accessory chosen. Reference Table
A.4 and Figure A.6 for guidance on how to properly set up
each accessory.
Local/Remote Switch
LOCAL/REMOTE
SWITCH
ON REMOTE
ON REMOTE
ON LOCAL
REMOTE
REMOTE
REMOTE
N/A N/A
REMOTE
ON LOCAL
INSTALLATION
® 600X-I will be
Wire Feeder Voltmeter
Polarity Switch
115/42VAC
SWITCH
N/A
N/A
N/A
42VAC
42VAC
115VAC
N/A
N/A
N/A