Problem
After the SmartLine
appliance has been
switched on or a sensor
control has been
touched, appears in
the timer display for a
few seconds.
The SmartLine
appliance has switched
off automatically. When
the appliance is
switched back on,
appears above the On/
Off sensor control.
After the SmartLine
appliance has been
switched on, appears
briefly in the timer
display. The SmartLine
appliance does not heat
up.
A cooking zone
switches itself off
automatically.
A cooking zone or the
whole cooktop switches
off automatically.
The Booster has
automatically switched
off early.
A cooking zone is not
working in the usual
way on the power level
selected.
Possible cause and remedy
The system lock or safety lock is activated.
Deactivate the system lock or safety lock (see
"Safety features - System lock / Safety lock").
One or more of the sensor controls are covered, e.g.
by finger contact, food boiling over, or an object.
Clean off any dirt and/or remove the object (see
"Safety features – Safety switch-off").
The SmartLine appliance is in demonstration mode.
Touch the 0 and 2 sensor controls at the same
time until flashes alternately with in the
timer display.
It has been operated for too long.
You can use the cooking zone again by switching
it back on (see "Safety features - Safety switch-
off").
The overheating protection mechanism has been
activated.
See "Safety features - Overheating protection".
The overheating protection mechanism has been
activated.
See "Safety features - Overheating protection".
The overheating protection mechanism has been
activated.
See "Safety features - Overheating protection".
Problem solving guide
45