E.p.a. Emission Controls - Mercury 565 Manual

OWNER'S WARRANTY RESPONSIBILITIES
As the sterndrive engine owner, you are responsible for the performance of the
required maintenance listed in your owner's manual. Mercury Racing
recommends that you retain all receipts covering maintenance on your
sterndrive engine, but Mercury Racing cannot deny warranty solely for the lack
of receipts or your failure to ensure the performance of all scheduled
maintenance.
As the sterndrive engine owner, you should however be aware that Mercury
Racing may deny you warranty coverage if your sterndrive engine or a part has
failed due to abuse, neglect, improper maintenance or unapproved
modifications.
You are responsible for presenting your sterndrive engine to a Mercury Marine
distribution center as soon as a problem exists. The warranty repairs will be
completed in a reasonable amount of time, not to exceed 30 days. If you have
any questions regarding your warranty rights and responsibilities, you should
contact Mercury Racing at 1‑920‑924‑2088.

E.P.A. Emission Controls

INTRODUCTION
Consistent with the obligations created by 40 CFR Part 1045, Subpart B,
Mercury Marine provides an emission warranty of three years or 480 hours of
engine use, whichever occurs first, to the retail purchaser for electrical
components of the emission control system, and one year or 150 hours of
engine use, whichever occurs first, to the retail purchaser for mechanical
components of the emission control system. The engine is designed, built, and
equipped to conform at the time of sale with applicable regulations under
section 213 of the Clean Air Act, and the engine is free from defects in
materials and workmanship that cause the engine to fail to conform with
applicable regulations.
EMISSION CONTROL SYSTEM COMPONENTS
The emission‑related warranty covers all components whose failure would
increase an engine's emission of any regulated component including the
following list of components:
1. Fuel metering system
a. Carburetor and internal parts (or fuel pressure regulator or fuel
injection system)
b. Air/fuel ratio feedback and control system
c. Cold start enrichment system
d. Intake valves
2. Air induction system
a. Controlled hot air intake system
b. Intake manifold
WARRANTY INFORMATION
10
eng