Setup And Use - Summit Dagger Instructions Manual

FOAM SEAT
NOTICE
The foam seat included with these treestands is
removable for storage. DO NOT leave your stand
outdoors when it is not being used.
FOAM SEAT
1. Position the seat inside of the seat climber frame.
2. Wrap the seat strap webbing over the frame from the
inside out as shown in figure 7.
3. Turn the three bar slide slightly sideways and push it
through the metal D buckle that is sewn onto the end of the
strap (figure 8).
RAPIDCLIMB STIRRUPS
1. Position the stirrup as shown in figure 9. The curved end of the stirrup should face down and in - toward the center of the
platform.
2. Once positioned secure with the supplied bolt and wing nut as shown in figure 10. Occasional readjustment might be
necessary as your footwear needs change or so that the stirrup will fit between the platform rungs when folding the platform
down. To adjust, simply loosen the wing nut and slide the stirrup up or down. It is not necessary to completely remove the nut
to adjust the stirrup.
3. Wrap the supplied bungee cord around one side of the curved platform upright bars and push the S-hook through the loop
as shown in figure 11. The bungee should always be attached ABOVE the stirrup on the tree side of the upright bars.
4. Pull the hook across the platform and loop it over the opposite upright bar. Hook it back over it self as shown in figure 12.
9
STIRRUP
6

SETUP AND USE

UNFOLDING YOUR STAND
1. Separate the seat climber from the platform.
2. Fold down the pivoting V-Brace and lock it into
position by fully screwing the threaded stud into the
stand as shown in figure 13.
3. Repeat for the seat climber and platform.
PG 4
BOLT AND WING NUT
HAND TIGHTEN
10
7
11
TOWARDS
TREE
13
8
12
www.summitstands.com