Summit Dagger Instructions Manual page 3

4
ASSEMBLY
COMFORT PADS - DAGGER
1. Position the two 12" Pads as shown in figure
1a. Secure each pad with two In-Line Cable Ties
as shown. Please note the Correct and Incorrect
ways of using the ties. Use a sharp knife or
snips to trim the excess. Rotate the clasp under
the pad after they have been trimmed.
1a
12" FOAM
PAD
(PN 70223)
BACKPACK STRAPS
1. Wrap the buckle end of the 2" wide V strap around
the first rung on the platform as shown in figure 2.
Push the 3 Bar Slide through the buckle as shown in
figure 3. The buckle should look like figure 4 when
complete. Pulling on the straps should cinch down the
buckle.
2. Place the looped end of the 1" wide strap around
the platform tubing at point A and bring the loose
end back through the loop as shown in figure 5. Pull
tight to create a cinch knot. Repeat for the other side.
3. Thread the loose end of each 1" strap through the
buckle on the 2" V strap as shown in figure 6.
4
Correct
Incorrect
IN-LINE
CABLE TIES
(PN 10656)
2
5
1" WIDE STRAP
(PN 30283)
A
COMFORT PADS - SWITCHBLADE
1. Position the two 12" Pads and the 18" Pad
as shown in figure 1b. Secure each pad with
two In-Line Cable Ties as shown. Please note
the Correct and Incorrect ways of using the ties.
Use a sharp knife or snips to trim the excess.
Rotate the clasp under the pad after they have
been trimmed.
1b
18" FOAM
PAD
IN-LINE (PN 70224)
CABLE TIES
(PN 10656)
3
2" WIDE STRAP
(PN 40274)
6
12" FOAM
PAD
(PN 70223)
PG 3