Summit Dagger Instructions Manual page 11

43
BACKPACKING - SWITCHBLADE
Your treestand is designed to "nest"
together as one unit making it easy to
transport.
1. Loosen the knob holding the
backbar secure and fold the arms
down as shown in figure 46. Untie the
umbilical rope from the seat climber
and wrap it around the platform yolk
several times to secure it.
2. Start with the seat climber portion of
the stand, set it flat as shown in figure
43. Fold the V-Brace up against the
cable.
3. Take the platform and slide it into
the seat climber so that its upright
braces and cable bracket are next to
the same areas on the seat climber as
shown in figure 47.
4. From this position, pull the seat
backrest through the large gap in the
platform as shown in figure 48.
5. Secure the seat to the stand by
running the seat bungee around the
frame and clipping it off. (figure 48)
6. The backpack straps will most likely
be wedged in behind the seat at this
point. Pull them out and around the
seat webbing and push the seat as far
down in the frame as possible.
7. Secure the top and platform
together with the 1" wide green strap
with the spring loaded tourniquet
buckle as shown in figure 49. This will
prevent seat the seat and the platform
from making noise as you hike to your
hunting location.
8. Use the backpack straps to carry the
unit on your back as shown in figure
50. Pull the loose end of the straps to
tighten and pull up on the buckle to
release.
44
46
48
50
45
1" GREEN
STRAP
(PN 30285)
47
49
1" GREEN
STRAP
(PN 30285)
PG 11