Fostex VF-160 Operation Manual page 117

When completing the save operation, "Save Completed!"
appears on the display (as shown below) and the VF160
stops access to the drive, while the disc in the CD-RW
drive is automatically ejected.
When saving data to more than one disc, the first disc
will be ejected when it is full (i.e. there is no more record-
ing space on the disc), while "Insert Disk!" appears on the
screen. After inserting the second disc, the VF160 auto-
matically resumes the save operation.
After completing the save operation, the final disc is
ejected and the above screen appears. (See <Note> below).
8. Press the [EXIT/NO] key (or the [STOP] key) to exit the Setup
mode.
<Note for saving data to more than one disc>
If you save data to more than one disc, we recom-
mend to put a number on each disc in the saving or-
der (such as DISC-1 , DISC-2 , etc.) so that you will eas-
ily know the order for inserting discs when loading
data.
<Note>
You cannot abort the save operation before com-
pleted. Especially during the save operation to more
than one disc, if you happen to press the [EXIT/NO]
key while removing or inserting a disc, you have to
redo the save operation from the beginning with the
first disc.
<About save error>
If an error occurs for some reason during the save
operation, the error message as below appears.
If it appears, press the [EXIT/NO] key.
The display returns to the previous screen before
performing the save operation.
Note that saved data before the error message ap-
pears is all invalid.
<Note>
If the message above appears while saving data to
a CD-R disc, you can no longer use the disc.
<Hint 1>
In the description for saving data above, we assume to
use a non-recorded CD-RW/CD-R disc.
If you use a recorded disc (including a disc on which
computer data is recorded), also note the following.
By performing step 5 in the save operation procedure
shown above ("While "BkUp" is flashing, press the [EN-
TER/YES] key".) When a recorded disc is inserted, the
display shows a warning message, followed by the con-
firmation screen (where "Sure?" flashes).
With this screen, you can choose whether erasing the
recorded data or ejecting the disc.
Flashing
• To erase the existing (recorded) data
Press the [ENTER/YES] key while both "ERASE" and "Sure?"
are flashing.
The display shows the screen below and the VF160 starts
erasing the disc.
As the erase process progresses, the number of flashing
"*" increases from left to right.
Flashing
Increases as the process progresses.
Immediately after completing erasing the disc, the
display shows the same screen (for selecting a
program to be saved) which appears after step 5
is performed. Hereafter, perform the same pro-
cedure as described above.
117
Flashing
Flashing