Fostex VF-160 Operation Manual page 106

You can select any existing program available on the
current drive by rotating the [JOG] dial besides "New PGM".
When selecting an existing program, the data size of the
program is also shown.
When you load the data to any existing program, the
backup data overwrites the existing data.
If you do not like to overwrite any track, select "New PGM".
<Note>
If the current drive disk (destination disk of loading
data) does not have enough available space for
accepting the loaded data, The display shows " Disk Full "
and the returns to the screen shown when carrying
out step 3.
5. Use the [JOG] dial to select the load destination program
and press the [ENTER/YES] key.
The data load to the selected program starts.
The following screen example shows that the "B01" data
on the backup disk is now being loaded to "P02" on the
current disk. As the data load goes on, the remaining
data size shown on the screen counts down.
<Note>
You cannot abort the load operation before completed
using SCSI, unlike the load operation using the S/PDIF
or adat signal.
When the load operation is completed, "Completed!"
appears, while the VF160 stops.
6. Press the [EXIT/NO] key (or the [STOP] key) repeatedly until
exiting the Setup mode.
Loading from more than one disk
The following procedure shows how to load song data
saved to two SCSI disks.
1. Insert the first disk (Disk-1) to the SCSI device.
2. Carry out the same procedures as steps 1 through 3 described
in the previous section "Loading from a single disk".
The display shows the screen for selecting a program
loaded.
If the program is saved over more than one disks, backup
file number "B01" flashes, as well as the recorded data
size is shown.
Flashing
• By using the [JOG] dial in this step, you can select
"Eject" as well as destination programs. To eject the
disk, select " Eject" and press the [ENTER/YES] key.
<Note>
If Disk-2 (the second disk when saving) is inserted in
mistake, the VF160 automatically recognized that the
wrong disk is set. The display shows " Wrong Disk ",
followed by " Illegal No! ", and the disk is automatically
ejected. Then, as the display shows " Insert Disk ", insert
Disk-1.
3. Press the [ENTER/YES] key.
The display shows the screen for selecting the destination
program to whicha data is loaded.
In the default setting, "New PGM" is selected so that the
data is loaded to a newly created program.
Flashing
You can select any existing program available on the
current drive by rotating the [JOG] dial besides "New PGM".
When selecting an existing program, the data size of the
current program is also shown.
When you select load data to an existing program, the
backup data overwrites the existing data.
If you do not like any track to be overwritten, select "New
PGM".
<Note>
If the current drive disk (destination disk of loading
data) does not have enough available space for
accepting the loaded data, The display shows " Disk Full "
and the returns to the screen shown when carrying
out step 3.
106