Campbell Hausfeld HU500000 Operating Instructions Manual page 3

General Safety Information
(Continued)
SprayInG preCaUtIOnS
Do not
spray
flammable materials in
vicinity of open flame or near
ignition sources including the
compressor unit.
14. Do not smoke when spraying paint,
insecticides, or other flammable
substances.
15. Use a face mask /
respirator when spraying
and spray in a well
ventilated area to prevent
health and fire hazards.
16. Do not direct paint or other sprayed
material at the compressor. Locate
compressor as far away from
the spraying area as possible to
minimize overspray accumulation on
the compressor.
17. When spraying or cleaning with
solvents or toxic chemicals, follow
the instructions provided by the
chemical manufacturer.
assembly
HanDle aSSeMbly (Figures 1 and 2)
1. Place ends of handle around tank
and into the mounting pipe. Align
holes in handle to holes in mounting
pipe.
2. Assemble four (4) screws (from parts
package) through holes in mounting
pipe and handle. Tighten screws.
Never use the
handle to lift the
unit completely off the ground. Only
use the handle to lift one end so the
wheels may be used to move the unit.
Figure 1 - Handle assembly
(horizontal unit)
Figure 2 - Handle assembly
(vertical unit)
3
WHeel aSSeMbly (Figures 3 and 4)
Wheel assembly kit includes:
- 2 wheels *
- 2 axle bolts *
- 2 washers *
- 2 nuts *
- 2 wheel inserts *
The items marked with an asterisk (*)
were shipped loose with the unit.
1. Wheel has an offset hub. Place
wheel insert into center of hub. With
offset hub facing axle iron, assemble
axle bolt through washer and then
holes in wheel and axle iron.
2. Place lock washer on axle bolt. Then
tighten nut securely to threaded part
of axle bolt.
3. Repeat procedure with other side.
Screws
Nut
Figure 3 - Wheel assembly
Screws
Nut
Figure 4 - Wheel assembly
HU500000, HU502000
Axle Iron
Wheel
Washer
Wheel Insert
Axle Bolt
(horizontal unit)
Axle Iron
Wheel
Washer
Wheel Insert
Axle Bolt
(vertical unit)
www.chpower.com