Something Not Working - AEG LAVATHERM 57700 Operating Instructions Manual

Something not working?

Something not working?
If the tumble dryer is not working correctly please carry out the follow-
ing checks before calling an engineer.
The tumble dryer will not start
The results are unsatisfactory
The drying result is unsatis-
factory; the washing is still
damp.
28
Symptom Possible cause
The appliance is not
plugged in
The fuse has blown
The START/PAUSE button
has not been pressed
No program has been
selected
The door is not properly
closed
The water reservoir is full
The wrong program has
been selected
Fluff filter blocked
Condenser covered with
fluff
The tumble dryer has
been overloaded
Laundry not sufficiently
spun prior to tumble
drying
The vent in the base of
the appliance is covered
A residue may have
formed on the drum
interior, blocking the
sensors
The conductivity of the
water in your locality dif-
fers from the standard
setting of the appliance.
Solution
Plug in the appliance
Check the fuse
Press the START/PAUSE
button
Select the required
program
Close the door
Empty the water reservoir
Select a different
program
Clean the fluff filter
Clean the condenser
Observe the maximum
loads stated for each
program
Ensure the wash load is
well spun before tumble
drying
Ensure the vent is clear
Clean the inside of the
drum with white vinegar
Reprogram the standard
setting, eg. H0 instead of
H1, for dryer washing (see
chapter "Programming
Possibilities".