Something Not Working - AEG Lavamat Trophy series Operating Instructions Manual

Something not working?

Something not working?
If the tumble dryer is not working correctly please carry out the follow-
ing checks before calling out an engineer.
Please note that it will be necessary to provide proof of purchase for
any in-guarantee service calls.
In-guarantee customers should ensure that the checks listed below
have been made as the engineer will make a charge if the fault is not a
mechanical or electrical breakdown. .
The tumble dryer does not
work
The drying results are
unsatisfactory
The drying process takes
unusually long
24
Problem Possible cause
The appliance is not
plugged in
The fuse has blown
The STARTbutton has not
been pressed
No program has been
selected
The door is not properly
closed
The wrong program has
been selected
Fluff filter blocked
The tumble dryer has
been overloaded
Laundry not sufficiently
spun prior to tumble
drying
A residue may have
formed on the drum
interior, blocking the
sensors
Fluff filter blocked
The vent hose may be
obstructed
Remedy
Plug in the appliance
Check the fuse
Press the START button
Select the required
program
Close the door
Select a different
program
Clean the fluff filter
Observe the maximum
loads stated for each
program
Ensure the wash load is
well spun before tumble
drying
Clean the inside of the
drum with white vinegar
Clean the fluff filter
Check the vent is not
blocked or squashed