Dimension One Spas BAY Series Owner's Manual page 22

BAY Collection
Water Fill Volume by Model
Model
Amore Bay .......................415 Gal (1,571 L) ................................ 10.4 oz
Lotus Bay.........................375 Gal (1,420 L) ................................ 9.4 oz
Sarena Bay ......................500 Gal (1,893 L) ................................ 12.5 oz
*Use average fill volume for chemical maintenance
9. Leave hot tub cover open during this step to allow excessive
chemical vapors to exit hot tub, protecting pillows and plastic knobs
from chemical attack. If hot tub is indoors, open doors and windows
for proper ventilation. Turn on all hot tub jet pumps for 1 hour and
place all massage selector knob(s) in their center "combo" position.
Note: You will need to activate the jet pumps every 30 minutes since
these functions have an automatic 30-minute time-out that turns them off.
WARNING:
!
• To decrease the risk of injury, drowning or entrapment, nev-
er leave your hot tub unattended for any reason while the
cover is open and accessible, especially to small children
and animals!
• Use the hot tub straps and clip tie downs to secure the cover
when not in use. This will help to discourage unsupervised
children from entering the hot tub and keep the hot tub cover
secure in high wind conditions. There is no representation
that the cover, clip tie downs, or actual locks will prevent
access to the hot tub.
• Precautions should be taken to minimize your exposure
to chemical vapors (that could cause lung, brain, or skin
damage).
10. Turn off power to the hot tub at the circuit breaker, then drain tub as
outlined in Section 13.5.
11. Refill hot tub with clean tap water from garden hose. Fill the spa
until the water level is about 6" below the top of the spa. (DO NOT
OVERFILL!).
CAUTION: TO DECREASE BUILD UP ON COMPONENTS AND
MINIMIZE ACRYLIC DAMAGE.
Never fill with water from a water softener. If your water is extremely
"hard," it is preferable to fill halfway with hard water and the rest of
the way with softened water. Water that is too soft can be corrosive
to metal components.
Page 18
Average
Fill Volume*
RISK OF PERSONAL INJURY!
Sodium
Dichlor