Power Requirements; North American 120/240V Convertible 60Hz Models; Export 230V 50Hz Models; Hot Tub Fill Up Procedure - Dimension One Spas @HOME Series Owner's Manual

@Home Collection
7.0

Power Requirements

7.1

North American 120/240V Convertible 60Hz Models

Model
@Home
Collection
7.2

Export 230V 50Hz Models

Model
@Home
Collection
8.0

Hot tub Fill Up Procedure

For best results, read each step in its entirety before proceeding with this
procedure. Make sure all drains are closed before you begin.
IMPORTANT NOTICE
drain hose bib, that is packaged in the warranty pack,
on to the hot tub. Securely screw in and close the drain
valve and drain cap.
Pre-installation tip
Ask your dealer to check on the following items during
installation. If your dealer/electrician is not setting up your tub, you
can easily do these two tasks yourself by removing the front panel of
equipment compartment using a Phillips screwdriver.
• Check that the pump unions are hand tight to prevent possible
leakage.
• Remove the shipping bolts located on the front of the pump mount if
they have not yet been removed.
1. Prepare The Hot tub For Filling
• Clear all debris from the hot tub. (Although the hot tub shell has
been polished at the factory, you may want to treat it with a specially
formulated hot tub cleaner.) Consult your authorized Dimension One
dealer for additional information prior to filling hot tub.
• Remove the filters as illustrated in Section 11.1.
Page 16
Power Branch Circuit
120V GFCI Cord
240V 3 wires + Ground
240V 3 wires + Ground
Power Circuit Protection
230V
: Make sure to install the
Circuit
Protection
1 x 32A
2 x 16A
3 x 16A
Wire
Gauge
GFCI
15A cord
30A #6 awg
40A #6 awg
Figure 8.0a