Ethernet Host Interface - Bosch APC‑AMC2‑4WCF Installation Manual

Access Modular Controller 2
4.8

Ethernet Host Interface

The AMC2-4W offers a 10/100 Mbit/s Ethernet auto-sensing interface to connect to a local
area network or host computer.
Notice!
Use a CAT5 or higher version to connect the AMC2-4W with the network.
A complete connection diagram of the Ethernet host interface is shown in chapter Connecting
Diagrams, page 43.
Figure 4.8: Location of the Ethernet interface
Notice!
After connecting a new AMC2 device to a network using DHCP, it can take some time before
the new AMC2 device is recognized by the remote server.
You can accelerate this process by running the following command:
ipconfig /flushdns
This makes the AMC2 device immediately available by its name.
Bosch Security Systems B.V. Installation manual
Installing | en 21
2020-01 | V02 |