Performance Characteristics - Bosch APC‑AMC2‑4WCF Installation Manual

10 en | Introduction
Figure 3.4: Overview - Interfaces
Notice!
All connectors, with the exception of the RS-232 and Ethernet host interface, are pluggable
screw clamp terminals.
Figure 3.5: Jumper at the bottom side
3.3

Performance Characteristics

–
–
–
2020-01 | V02 |
13 RS-485 extension module bus
14 External tamper contact
15 Connector for power supply
16 RS-485 interfaces for up to 8 card readers
17 Connectors for eight analog inputs
18 Connectors for eight relay outputs
19 Jumper for setting either voltage free relay output ("dry" mode) or looped-in voltage
from the AMC2 internal power supply ("wet" mode).
20 Jumper: Equalization of potential between different systems and earth ground
(shield) for the extension interface.
Intelligent access manager for 1 - 8 entrances (for example doors, man traps, barriers)
Host address selectable using DIL sliding switch.
Four possible configurable host interfaces:
– Ethernet (= standard)
– RS-485 2-wire
Installation manual
Access Modular Controller 2
Bosch Security Systems B.V.