Fortinet FortiGate FortiGate-5001FA2 Installation Manual page 21

Configuring the FortiGate for the Network
FortiGate-5000 series Installation Guide
Configuring the FortiGate module to operate in NAT/Route mode
Use the information that you gathered in
procedures.
To add/change the administrator password
1 Log in to the CLI.
2 Change the admin administrator password. Enter:
config system admin
edit admin
set password <psswrd>
end
To configure interfaces
1 Log in to the CLI.
2 To set the IP address and netmask of port1, enter:
config system interface
edit port1
set ip <address_ip> <netmask>
end
Example
To set the IP address of port1 to 192.168.20.99 and netmask to 255.255.255.0, enter:
config system interface
edit port1
set ip 192.168.20.99 255.255.255.0
end
3 To set the IP address and netmask of port2, enter:
config system interface
edit port2
set ip <address_ip> <netmask>
end
Example
To set the IP address of port 1 to 204.23.1.5 and netmask to 255.255.255.0, enter:
config system interface
edit port1
set ip 204.23.1.5 255.255.255.0
end
To set port2 to use DHCP, enter:
config system interface
edit port2
set mode dhcp
01-28011-0259-20060210
NAT/Route mode installation
Table 1 on page 18 to complete the following
21