Dimensions And Weight; Bodywork - Audi RS 3 LMS DSG User Manual

Dimensions and weight

Dimensions
Overall length
Overall bodywork front width
Overall bodywork rear width
Wheel base
Over hang front splitter
Over hang front bumper
Over hang rear
Over hang rear wing*
Minimum ground clearance
Weight
Total weight in race conditions without fuel
Car balance
Distribution weight/power
Notes:
* Measured from the rear bumper to the end of rear wing profile.
** The scrutineering dimensions and minimum weight are the ones on the Audi RS 3 LMS DSG Technical
Form.

Bodywork

Part number Description
01 Bonnet
02 Left / right front door
03 Left / right rear door
04 Roof
05 Boot lid
10 Roof hatch
11 Bonnet opening
12 Front splitter
13 Fender air exit
14 Front bumper
15 Rear bumper
16 Left / right side trim
17 Left / right rear door extension
18 Left / right rear fender extension
19 Left / right front fender
20 Diffuser
Measurements Remarks
4589 mm
1950 mm
1950 mm
2665 mm
874 mm
844 mm
954 mm
96 mm From the wing to the bumper
- 80 mm according to TCR regulations
Measurements
1215 kg **
59,5% front / 40,5% rear
3,47 kg/hp
Material
Steel
Steel
Steel
Steel
Steel
Carbon
Carbon (painted)
Carbon
Carbon (painted)
Fiberglass
Fiberglass
Carbon + Kevlar
Carbon (painted)
Carbon (painted)
Carbon (painted)
Carbon (painted)
5