Starting Warm Engine - Echo SRM-3020U Operator's Manual

Hide thumbs

Table Of Contents

Table of Contents

OPERATION

Choke

Move choke lever (B) to COLD

START position.

Purge Bulb

Pump purge bulb (C) until fuel is

visible and flows freely in the

clear fuel tank return line. Pump

bulb an additional four or five

times.

Note: Lightly place knee on

drive shaft to stabilize unit

during starting. Do not

apply excessive

downward force or

damage to unit can occur.

Recoil Starter

Lay the unit on a flat area and keep movable attachment parts clear of all

obstacles. Firmly grasp throttle handle and throttle trigger lockout with left

hand and fully depress throttle trigger to wide open position. Rapidly pull

recoil starter handle/rope (D) until engine fires (or maximum five pulls).

Choke

After engine fires (or five pulls),

move choke lever back to RUN

position. Firmly grasp throttle

handle (E) and throttle trigger

lockout with left hand and fully

depress throttle trigger to wide

open position. Pull recoil starter

handle until engine starts and

runs. Release throttle trigger,

and allow unit to warm up at idle

for several minutes.

Note: If engine does not start with choke in "RUN" position after five

pulls, repeat instructions 2 - 5.

Throttle Trigger

After engine warm-up, grip throttle handle and support handle. Depress

the throttle trigger lockout, and gradually depress throttle trigger to

increase engine RPM to operating speed.