Mercury 40 SeaPro Operation, Maintenance & Installation Manual page 93

3. Do not install wedges or plates between the transom clamp brackets and
the transom (or jack plate). Refer to Figure 4.
a
BOAT HORSEPOWER CAPACITY
Exceeding the boat's maximum horsepower rating can cause serious injury
or death. Overpowering the boat can affect boat control and flotation
characteristics or break the transom. Do not install an engine that exceeds
the boat's maximum power rating.
Do not overpower or overload your boat. Most boats will carry a required
capacity plate indicating the maximum acceptable power and load as
determined by the manufacturer following certain federal guidelines. If in doubt,
contact your dealer or the boat manufacturer.
U.S. COAST GUARD CAP ACITY
MAXIMUM HORSEPOWER XXX
MAXIMUM PERSON
MAXIMUM WEIGHT
FASTENING THE OUTBOARD TO THE TRANSOM
Mounting Bolts
Outboard Transom Mounting Hardware ‑ Supplied with Outboard
Part Number
8M0071543 Outboard mounting bolt ½‑20 x 5.00 in. long (3.25 in. thread)
eng
INSTALLATION
b
c
54058
!
CAPACITY (POUNDS)
CAPACITY
Part Name
Figure 4
a - Boat transom or jack plate
b - Transom clamp bracket
c - Wedge/plate
WARNING
83
XXX
XXX
26777
Description