Mercury 40 SeaPro Operation, Maintenance & Installation Manual page 57

9. Remote control models ‑ Move on/off switch to the on position.
NOTE: Manual starting models ‑ For initial start of a new engine or first start
after a prolonged storage, primer lines may have air in them. In this case, push
in the primer bulb several times until fluid can be felt and then the normal 4 to
6 rapid primes.
10. Manual starting models ‑ If engine is cold, push in the primer bulb rapidly
4 to 6 times.
a. Pull the starter rope slowly until starter engages, then pull rapidly to
crank the engine.
b. Allow rope to return slowly. Repeat until engine starts. If engine begins
to stall, re‑prime until engine is running.
11. Electric starting models ‑ Turn ignition key to the START position and start
the engine. If engine is cold, push in on key to choke engine. If engine
fails to start in 10 seconds, wait 30 seconds and try again. If engine
begins to stall, re‑prime (push key in) until engine is running.
eng
OPERATION
47
3026
3076
3072