Lenovo RackSwitch G8332 Installation Manual page 85

4. Configure the default gateway.
© Copyright Lenovo 2017
 for Lenovo Cloud Network Operating System (CNOS):
G8332(config­if)# ip address 10.254.87.6
G8332(config­if)# ip netmask 255.255.255.0
G8332(config­if)# vlan 1
G8332(config­if)# exit
G8332(config)#
 for Lenovo Enterprise Network Operating System (ENOS):
G8332(config)# ip gateway 4 address 205.21.17.1
G8332(config)# ip gateway 4 enable
 for Lenovo Cloud Network Operating System (CNOS):
G8332(config)# ip route 0.0.0.0/0 205.21.17.1
After you configure the IP address for your switch and you have an existing
network connection, you can use the Telnet program from an external
management station to access and control the switch. The management station and
your switch must be on the same IP subnet.
The switch CLI allows you to configure and control the switch over the network
using the Telnet program. You can use the CLI to perform many basic network
management functions. In addition, you can configure the switch for management
using an SNMP‐based network management system or a web‐browser.
For more information about using the CLI, see the Command Reference guide for
your specific switch and firmware version.
Chapter 5: Initializing the G8332
85