Table of Contents Introduction 3 Requirements 3 Connect to the Switch 3 Over the Network 3 Setup the Switch for Remote Access 4 Configure the IP Information 4 Use SSH to Access the Switch 4 Configure Users and Passwords 5 ...
Introduction This guide provides general configuration examples. The configurations found here may not be applicable for all environments. Consult Lenovo’s official documentation for further information in regards to your environment's unique configuration. Requirements ● A Terminal Emulation program, such as PuTTY. ...
Setup the Switch for Remote Access Configure the IP Information 1. Login to the switch using either option in the C onnect to the Switch section above. 2. Run the commands below to configure the settings for remote access. The interface you select will depend on how you've connected to the switch. ...
Configure the Switch Configure the Ports 1. Login to the switch. 2. Run the commands below to configure the port settings for the switch. The interface you select will depend on how you've connected to the switch. enable configure device interface <management|ethernet>...
Feedback & Support Document Feedback Scale Computing welcomes your suggestions for improving our documentation. Please send your feedback to documentation@scalecomputing.com . Technical Support and Resources There are many technical support resources available for use. Access this document, and many others, at http://www.scalecomputing.com/support/login/...