Serial Port Module - HP ProDesk 480 G4 MT Maintenance And Service Manual

Serial port module

Follow these steps to remove the serial port module:
1. Prepare the computer for disassembly (see
2. Remove the access panel (see
3. Position the computer with the rear panel toward you.
4. Disconnect the serial port module cable (1) from the system board.
5. Remove the two 3/16" screwlocks (2) that secure the serial port module to the computer chassis.
6. Remove the serial port module (3).
Reverse this procedure to install the serial port module.
Preparation for disassembly on page
Access panel on page 22).
21).
Serial port module 27