Propeller Replacement-Command Thrust Gearcase - Mercury 40 CT Maintenance And Installation Manual

9. Place the propeller nut retainer over the pins. Place a block of wood
between the gearcase and the propeller and tighten the propeller nut to
the specified torque.
Description
Propeller nut
10. Align the flat sides of the propeller nut with the tabs on the propeller nut
retainer. Secure the propeller nut by bending the tabs up and against the
flats on the propeller nut.
a
b
11. Install the spark plug leads.
Propeller Replacement—Command Thrust Gearcase
Rotating the propeller shaft may cause the engine to crank over and start. To
prevent this type of accidental engine starting and possible serious injury
caused from being struck by a rotating propeller, always turn the ignition key
or lanyard stop switch to the "OFF" position and remove the spark plug leads
from the spark plugs while servicing.
1. Shift the outboard to the neutral ("N") position.
eng
MAINTENANCE
b
a -
b -
a
26906
WARNING
!
N
Nm
75
Pins
Tabs
N
59
lb‑in. lb‑ft
–
28528
55