Starting The Engine - Tiller Handle Models - Mercury 40 CT Maintenance And Installation Manual

WARMING UP ENGINE
Before beginning operation, allow the engine to warm up at idling speed for
three minutes.
Starting the Engine ‑ Tiller Handle Models
Before starting, read the Prestarting Check List, special operating
instructions, and Engine Break‑in Procedure in the Operation section.
Without sufficient cooling water, the engine, the water pump, and other
components will overheat and suffer damage. Provide a sufficient supply of
water to the water inlets during operation.
1. Open fuel tank vent screw (in filler cap) on manual venting type fuel tanks.
2. Connect the remote fuel line to the outboard. Make sure the connector is
snapped into place.
3. Position the fuel line primer bulb so the arrow on the side of the bulb is
pointing up. Squeeze the fuel line primer bulb several times until it feels
firm.
eng
OPERATION
NOTICE
27348
41
19748
28526