Table of Contents
Advertisement
FCT
Explanation
SM2
Move stepping motor SM2 (feed regulator)
Positions the feed regulator in the position entered by selecting the type "POS"
and entering the desired value using the corresponding +/- keys. The feed regula-
tor is moved to the reference position by selecting the type "REF" and confirming
the selection using the corresponding +/- keys.
DM
Set main drive
Positions the main drive in the position entered by selecting the type "POS" and
entering the desired value using the corresponding +/- keys.
The value for the speed is changed accordingly by selecting the type "SPD" and
entering the desired value using the corresponding +/- keys.
The value for the stitch count is changed accordingly by selecting the type "SC"
and entering the desired value using the corresponding +/- keys.
RES
Perform a reset
The values for all parameters are reset (master reset) by selecting the type "PAR"
and confirming the selection using the corresponding +/- keys.
All seam programs are deleted by selecting the type "PRG" and confirming the se-
lection using the corresponding +/- keys.
TM
Set bobbin thread monitor
The transmission power of the bobbin thread monitor "Tx" can be changed using
the corresponding +/- key.
PS
Set transmitted light sensors
The transmission power of the transmitted light sensors "Tx" can be changed (Lo/
Hi) using the corresponding +/- key.
VER
Display software version
Adjustment
47
Advertisement
Table of Contents
