Yamaha xvs650a Supplementary Service Manual page 24

G To the throttle position sensor (TPS).
H To the carburetor.
I To the fuel tank.
J Pass the neutral switch lead, pickup coil lead and
A.C. magneto lead under the ignition coil lead,
thermo switch lead and throttle position sensor
(TPS) lead.
K From the engine.
L 20 mm
M Pass the thermo switch lead inside of the silencer
breather hose.
CABLE ROUTING
N Fasten the wire harness and throttle position
sensor (TPS) lead with a plastic locking tie.
O Inside the motorcycle.
P Route the wire harness and throttle position sensor
(TPS) lead so they run along the bottom of the
frame tube.
Q Place the end of the plastic locking tie as shown.
R Fasten the wire harness with a plastic locking tie.
S Pass the wire harness between the air filter case
groove and frame.
–16–
SPEC