Rear Wheel - Yamaha TT-R50E Owner's Manual

1. Slot
2. Retainer
3. Lower the front wheel so that it is
on the ground, and then put the
sidestand down.
4. Install the washer and axle nut,
and then tighten the axle nut to the
specified torque.
Tightening torque:
Axle nut:
35 Nm (3.5 m·kgf, 25 ft·lbf)
5. Connect the brake cable to the
brake camshaft lever, and then in-
stall the brake lever free play ad-
justing nut on the brake cable.
PERIODIC MAINTENANCE AND ADJUSTMENT
TIP
If the spring was removed, install it
onto the brake cable with its smaller di-
2
ameter end facing down.
1
1
2
1. Brake cable
2. Spring
6. Adjust the brake lever free play.
(See page 7-15.)
7. While applying the front brake,
push down hard on the handlebar
several times to check for proper
fork operation.
8. Install each front fork leg guard by
installing the bolts.

Rear wheel

To remove the rear wheel
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the axle nut.
1. Axle nut
2. Washer
3. Drive chain slack adjusting nut
4. Locknut
5. Drive chain puller
7-28
WARNING
4
3
2
1
5
EAU25081
EAU56731
EWA10822
7