Toro 74235 Operator's Manual page 5

Be aware that loss of traction may occur going
downhill. Weight transfer to the front wheels may
cause drive wheels to slip and cause loss of braking
and steering.
Always avoid sudden starting or stopping on a slope. If
tires lose traction, disengage the blades and proceed
slowly off the slope.
Follow the manufacturer's recommendations for wheel
weights or counterweights to improve stability.
Use extreme care with grass catchers or other
attachments. These can change the stability of the
machine and cause loss of control.
Using the Rollover Protection System (ROPS)
A rollbar is available and its use is recommended for
areas where there are slopes, drop–offs or water.
When operating a machine with ROPS always use the
seat belt.
Be certain that the seat belt can be released quickly if
the machine is driven or rolls into ponds or water.
Check carefully for overhead clearances (i.e. branches,
doorways, electrical wires) before driving under any
objects and do not contact them.
Maintenance and storage
Disengage drives, lower implement, set parking brake,
stop engine and remove key or disconnect spark plug
wire. Wait for all movement to stop before adjusting,
cleaning or repairing.
Clean grass and debris from cutting units, drives,
mufflers, and engine to help prevent fires. Clean up oil
or fuel spillage.
Let engine cool before storing and do not store near
flame.
Shut off fuel while storing or transporting. Do not store
fuel near flames or drain indoors.
Park machine on level ground. Never allow untrained
personnel to service machine.
Use jack stands to support components when required.
Carefully release pressure from components with
stored energy.
Disconnect battery or remove spark plug wire before
making any repairs. Disconnect the negative terminal
first and the positive last. Reconnect positive first and
negative last.
Use care when checking blades. Wrap the blade(s) or
wear gloves, and use caution when servicing them.
Only replace blades. Never straighten or weld them.
Keep hands and feet away from moving parts. If
possible, do not make adjustments with the engine
running.
Charge batteries in an open well ventilated area, away
from spark and flames. Unplug charger before
connecting or disconnecting from battery. Wear
protective clothing and use insulated tools.
Keep all parts in good working condition and all
hardware tightened. Replace all worn or damaged
decals.
Use only Toro-approved attachments. Warranty may
be voided if used with unapproved attachments.
5