Table of Contents
Advertisement
1. Raise the height-of-cut lever to the transport position
(also the 5 in. (127 mm) cutting height position)
(Fig. 20).
2. To adjust, remove hairpin cotter and clevis pin from
height-of-cut bracket (Fig. 20).
3. Select hole in height-of-cut bracket corresponding to
the height-of-cut desired and, insert clevis pin
(Fig. 20).
4. Secure clevis pin with hairpin cotter (Fig. 20).
5. Move lever to selected height.
Figure 20
1. Height of cut lever
2. Clevis Pin
Using the Lift Assist Lever
The lift assist lever is used along with the height–of–cut
lever for raising the deck. This allows for easier raising of
the deck.
1. Place your foot onto lift assist lever.
2. Press on lift assist while pulling up on height–of–cut
lever (Fig. 21).
1
Figure 21
1. Lift Assist Lever
1
2
3
M–4164
3. Hairpin Cotter
m–5028
22
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut it is
recommended to adjust the height of the anti-scalp rollers.
1. Disengage the power take off (PTO) and turn the
ignition key to off. Move levers to neutral locked
position and apply parking brake. Remove the key.
2. After adjusting height-of-cut remove flange nut and
spring disk while holding stud with wrench (Fig. 22).
Note: Do not remove the wheel nut and washer (Fig. 22).
3. Select hole so gage wheel is positioned to the nearest
corresponding height-of-cut desired (Fig. 22).
4. Reinstall the flange nut and spring disk. Torque to
40–45 ft.–lb. (54–61 N m) (Fig. 22).
5. Repeat adjustment on other gage wheels.
4
3
2
Figure 22
1. Gage Wheel
2. Stud
3. Spring Disk
Positioning the Seat
The seat can move forward and backward. Position the
seat where you have the best control of the machine and
are most comfortable.
1. To adjust, move the lever sideways to unlock seat
(Fig. 23).
2. Slide the seat to the desired position and release lever
to lock in position.
1
5
m–4161
4. Flange Nut
5. Wheel nut and washer. Do
Not Remove.
Advertisement
Table of Contents
