Table of Contents
Advertisement
6. Close fuel shut off valve, on front panel before
transporting or storing machine.
Important
Make sure that the fuel shut off valve is
closed before transporting or storing the machine, as fuel
leakage may occur. Set the parking brake before
transporting. Make sure to remove the key as the fuel
pump may run and cause the battery to lose charge.
Caution
Children or bystanders may be injured if they
move or attempt to operate the tractor while it is
unattended.
Always remove the ignition key and set the
parking brake when leaving the machine
unattended, even if just for a few minutes.
Operating the Power Take Off
(PTO)
The power take off (PTO) switch engages and disengages
power to the electric clutch.
Engaging the PTO
1. While seated in the seat, release pressure on the
traction control levers and place in neutral.
2. Place throttle to the fast position.
3. Pull out on the power take off (PTO) switch to engage
(Fig. 18).
1
Figure 18
1. PTO—Off
Disengaging the PTO
1. To disengage push the PTO switch to the off position
(Fig. 18).
2
m–4201
2. PTO—On
20
The Safety Interlock System
Caution
If safety interlock switches are disconnected or
damaged the machine could operate unexpectedly
causing personal injury.
Do not tamper with the interlock switches.
Check the operation of the interlock switches
daily and replace any damaged switches before
operating the machine.
Understanding the Safety Interlock
System
The safety interlock system is designed to prevent the
engine from starting unless:
You are sitting on the seat.
The parking brake is engaged.
The power take off (PTO) is disengaged.
The motion control levers are in neutral locked
position.
The safety interlock system also is designed to stop the
engine when the traction controls are moved from the
locked position with the parking brake engaged or if you
rise from the seat when the PTO is on engaged.
Testing the Safety Interlock System
Test the safety interlock system before you use the
machine each time. If the safety system does not operate
as described below, have an Authorized Service Dealer
repair the safety system immediately.
1. Sitting on the seat, engage the parking brake and move
PTO to on. Try starting the engine; the engine should
not crank.
2. Sitting on the seat, engage the parking brake and move
PTO to off. Move either motion control lever (out of
neutral locked position). Try starting the engine; the
engine should not crank. Repeat for other control
lever.
3. Sitting on the seat, engage the parking brake, move
PTO switch to off and move the motion control levers
to neutral lock position. Now start the engine. While
the engine is running, release the parking brake,
engage the PTO and rise slightly from the seat; the
engine should stop.
4. Sitting on the seat, engage the parking brake, move
PTO switch to off and move the motion control levers
to neutral lock position. Now start the engine. While
Advertisement
Table of Contents
