Install Cowling; Checking Power Trim And Tilt System - Yamaha FL150A Owner's Manual

Operation
nected, cooling water can leak out and the
engine can overheat during operation.
[ECM01801]
1
1. Fitting
2. Flushing device
EMU36941

Install cowling

1. Be sure that all cowling lock levers are re-
leased.
2. Be sure that the rubber seal is seated all
the way around the engine.
3. Place the cowling on top of the seal.
4. Check to be sure it fits properly in the rub-
ber seal.
5. Move the levers to lock the cowling as
shown. NOTICE: If the top cowling is
not installed correctly, water spray un-
der the top cowling can damage the
engine, or the top cowling can blow off
at high speeds.
44
2
ZMU06159
[ECM01991]
ZMU06131
After installing, check the fitting of the top
cowling by pushing it with both hands. If the
top cowling is loose, have it repaired by your
Yamaha dealer.
EMU29158

Checking power trim and tilt system

EWM01930
WARNING
Never get under the lower unit while it is
G
tilted, even when the tilt support lever is
locked. Severe injury could occur if the
outboard motor accidentally falls.
Body parts can be crushed between the
G
motor and the clamp bracket when the
motor is trimmed or tilted.
Be sure no one is near the outboard mo-
G
tor before performing this check.
1. Check the power trim and tilt unit for any
sign of oil leaks.
ZMU06132