Engine Shut-Off Cord (Lanyard); Engine Oil; Engine; Flushing Device - Yamaha FL150A Owner's Manual

EMU36483

Engine shut-off cord (lanyard)

Inspect the engine shut-off cord and clip for
damage, such as cuts, breaks, and wear.
1. Cord
2. Clip
3. Engine shut-off switch
1. Cord
2. Clip
3. Engine shut-off switch
EMU37052

Engine oil

1. Put the outboard motor in an upright po-
sition (not tilted). NOTICE: If the motor
is not level, the oil level indicated on
the dipstick may not be accurate.
[ECM01790]
2. Remove oil dipstick and wipe it clean.
3. Insert the dipstick and remove it again.
Be sure to completely insert the dipstick
into the dipstick guide, otherwise the oil
level measurement will be incorrect.
4.
ON ON
OFF START OFF START
3
2
1
ZMU04564
EMU27153

Engine

G
G
G
G
EMU36492

Flushing device

Check that the flushing device's garden hose
connector is securely screwed on to the fitting
on the bottom cowling. NOTICE: If the gar-
den hose connector is not properly con-
Check the oil level using the dipstick to be
sure the level falls between the upper lev-
el mark and lower level mark. Consult
your Yamaha dealer if the oil level is out
of specified level or if it appears milky or
dirty.
1. Oil dipstick
1
1. Oil dipstick
2. Lower level mark
3. Upper level mark
Check the engine and engine mounting.
Look for loose or damaged fasteners.
Check the propeller for damage.
Check for engine oil leaks.
Operation
1
ZMU06221
3
2
ZMU07056
43