Before You Start; Cabinet Preparation; Tools Needed - Fisher & Paykel GC912 Installation Instructions Manual

Before you start

Cabinet preparation

Make sure that the countertop is flat and
level and that no structural members
interfere with space requirements.
Make sure the countertop is made of a heat
resistant material.
We recommend that the exposed bare
wood edges of the cutout be sealed
with an oil based paint or moisture proof
polyurethane to prevent possible damage
from moisture creeping between the
cooktop trim and the countertop.
Electrical
Make sure that there is a power supply
receptacle (110-120V 60Hz) within reach
of the cooktop power cord (30" from the
middle of the product). The main cable
must not touch any hot metal parts.
Make sure the cooktop is connected to
a power supply socket that is electrically
grounded in accordance with local codes
or in the absence of local codes, with the
National Electric Code ANSI/FPA 70 or CSA
22.2 (Canada).
The power supply must be properly
polarized. Reverse polarity will result in
continuous sparking of the electrodes, even
after flame ignition. If the power supply is
not properly polarized, it is the responsibility
of the customer to have the polarity
corrected.
If there is any doubt as to whether the
wall receptacle is properly grounded or
polarized, have it checked by a qualified
electrician prior to installing the cooktop.
This appliance is equipped with a three
prong grounding plug for your protection
against shock hazard and should be
plugged directly into a properly grounded
receptacle. Do not cut or remove the
grounding prong from this plug.
Parts checklist
Gas cooktop base unit
Literature pack (includes LPG kit)
Elbow & blue washer (taped to power cord)
Regulator (in polystyrene)
Burner heads and caps (check polystyrene
carefully before discarding)
3 x burner grates/trivets (1 x center,
2 x outer)
Accessories pack (GC913 only)

Tools needed

Phillips No. 2 screwdriver
Plumbing fittings as required
Woodworking tools as required
Shut-off valve
Oil based paint (for sealing cutout)
For GC912 LP conversion
7 3
Ø / " x 1 / " (Ø2.5 x 45 mm) flat
64 4
screwdriver
9
/ " (7 mm) box spanner
32
For GC913 LP conversion
7 3
Ø / " x 1 / " (Ø2.5 x 45 mm) flat
64 4
screwdriver
Phillips No. 1 screwdriver
9
/ " (7 mm) box spanner
32
13
/ " (10 mm) ring spanner
32
EN
3